Wall installation

The ideal height to install the MICA on the wall is between 120 and 180 centimeters.

  1. Use the provided drilling guide to make two holes in the wall with a drill.
  2. Insert a mounting screw into each hole. Use dowels if necessary. Leave 8 mm protruding from the wall.
place the mounting screws in the wall
  1. Attach ferrules to the power cable.
attaches ferrules to the power cables
  1. Connect the power cable to the male power terminal (2 pins) provided in the box.
VAC power connector
  1. Route the power cable through the entry on the back cover of the housing.
pass the power supply cable through the hole in the rear casing

If your model has Sigfox, LoRaWan or GSM Cellular IoT (NB-IoT/LTE) connectivity, screw the antenna into the back cover before placing it on the wall.

screw the antenna before placing the MICA in the electrical box for convenience.
  1. To mount the housing to the wall, drive the screws through the mounting holes in the housing cover. Rotate the housing so that it is leveled and tighten the screws.
Tighten the screws after the housing has been placed in the electrical box.
  1. With the back cover of the housing fixed to the wall, connect the male power terminal to the female terminal on the PCB.

If your model has Sigfox, LoRaWan or GSM Cellular IoT (NB-IoT/LTE) connectivity, remember that you will need to connect the indoor antenna connector cable.

connect the indoor antenna cable
  1. To close the MICA, align the assembly guides with the assembly hooks (with the housing tilted) and close the lid.
    2. uses the assembly guides to close the MICA
  2. Secure the cover with the two lower assembly screws.
secure the housing with the lower screws

Ensure that the device is properly secured so that it does not cause damage if it falls on someone or something.

Download the installation manual

Has this article solved your doubts? Thank you for your response. There was a problem sending your response

Related articles