Before starting the installation

  1. Identify what type of installation you are going to perform: wall, electrical box or desktop.
  2. Check the characteristics of your MICA at the bottom of the box.
you can check the model and characteristics of the mica on the back of the box.
  1. Check the contents of the box.
  2. Remove the MICA from the box and take the back cover of the case. To do this you will need a Philips screwdriver. Remove the two screws at the bottom and undock the cover from the MICA.
remove the two screws on the bottom of the mica
disengages the mica back cover

If your model is connected by GSM, Cellular IoT, Sigfox or LoRaWan, please note that you will have to connect the inner cable of the antenna to its corresponding connector.

Important

  • Check that no electrical current is flowing during installation or maintenance of wall-mounted equipment.
  • To reduce risks, always have the equipment installed and maintained by qualified personnel.
  • Download the mobile application "inBiot Setup" to configure your MICA.
  • If you have any questions, please contact the support team through the form in the inBiot support page.

Download the installation manual

Has this article solved your doubts? Thank you for your response. There was a problem sending your response

Related articles